Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4.5 LIMITS OF USE
The product is intended for the use and operation described in chapter 3 of this manual.
The use of unsuitable material or not within the working range of the product can cause serious damage and impair
its proper functioning.
4.6 DANGER ZONES
The product in question is intended for use by qualified personnel duly instructed in its use, who are familiar with
the situations/problems relating to the use of products with cutting blades in the agricultural and professional sector
and who are aware of the characteristics and risks present in the working environment.
The product in question is characterised by assemblies and parts that are considered hazardous. All areas
considered dangerous with the exception of the cutting areas were duly protected.
The risk of cutting, shearing and abrasion remains in relation to the cutting zone.
Keep an adequate distance from the working area and cordon off the working area if there is a risk that third parties
may come into contact with the shaking area.
In order to limit risks in danger zones, appropriate prevention and protection measures were taken. Observe the
instructions, both procedural and relating to 'Personal Protective Equipment', given in this manual.
4.7 ENVIRONMENTAL OPERATING CONDITIONS
The environment in which the product is used is an outdoor environment protected against aggressive agents
such as corrosive vapours or sources of excessive heat.
Unless otherwise specified, the product is intended for use under the following environmental conditions:
➢ Below 1000m above sea level.
➢ Ambient temperature between 5°C and + 45°C. (24-hour average ≤ 35°C)
➢ Relative humidity 30% to 85% without condensation.
➢ Material temperature, where applicable < 45° C.
The use of the product and control systems under conditions other than those listed is not permitted.
In particular, the environment of installation and use must not feature:
Exposure to corrosive fumes;
•
Exposure to excessive humidity (above 80%) and rapid changes in humidity;
•
Exposure to excessive dust;
•
Exposure to abrasive dust;
•
Exposure to oily vapours;
•
Exposure to explosive dust or gas mixtures;
•
Exposure to salty air;
•
Exposure to vibration, impacts or abnormal shocks,
•
Exposure to weather outside permitted limits or dripping;
•
Exposure to high or rapid temperature variations (greater than 5K/h)
•
Presence of nuclear radiation
•
NOTE: For the ambient operating conditions of the battery (plug-in), also refer to the requirements in
paragraph 3.6.
4.8 VIBRATIONS
The product has been designed and constructed in such a way that risks from vibrations transmitted by the product
have been reduced to a minimum.
The vibrations produced by this product, depending on how it is used, in accordance with the information provided
and in compliance with current regulations, are not hazardous to the health of the operator.
Vibration level values expressed in m/s² are given in paragraph 2.2 in the technical data section of this manual.
0310.0353_04
82
Advertenties
Inhoudsopgave
