Inhoudsopgave
Advertenties
ADJUSTMENT OF THE MANUAL
TIMER PROGRAM (P6)
1. Turn on the device (see Device Starting).
2. Select the first or the second heating level. To do so,
press the heating level button
lights up on the display. See Chapter "Heating Le-
vel Setting". Alternatively, you can select a desired
temperature (see chapter "Temperature Setting").
Please note: The wall-mount ceramic fan heater will
be turned ON depending on the selected program and
run the last heating level or temperature you selected.
3. Press the shown week-timer button
4. Then the timer program is shown on the display.
Press and hold the week timer button
appears in the display.
5. Confirm your selection by pressing the OK
button
.
5
6. Now the number of the respective day of the week
is flashing (see the table). By pressing the plus
or minus
button, you can set the first day of the
7
week which the timer should be set for.
01. Monday
02. Tuesday
03. Wednesday 04. Thursday
05. Friday
06. Saturday
07. Sunday
7. Confirm your selection by pressing the OK
button
.
5
8. The number of the start time hours appears on the
display. You can adjust it by pressing the plus or
minus button
8
7
Please note: Please note that the start time must be
before the end time and that only hours (no minutes)
can be set. The start time and end time must relate to
the same day.
9. Confirm your selection by pressing the
OK button
.
5
38
GB/IE/NI
. The symbol
11
.
9
until „P6"
9
.
10. The number of the end time hours appears on the
display. You can adjust it by pressing the plus or
minus button
11. After 5 seconds, you will automatically switch to
the next week.
A
12. Now you can set the start and end times for each
day of the week one after another, as described in
items 8-10.
Please note: If you want to disable the timer for a day of
the week, select start and end time „00".
13. Once you have set all 7 days of the week, the
week timer is active. Depending on the function,
the indicators
If values
and
A
program is active or the device turns off automatically.
If values
and
A
program is not yet in use. Then the device switches off
after 30 seconds again. In the meantime, the fan runs
until the standby mode. Values
8
to blink until the program automatically intervenes
and turns the device on.
DEACTIVATION OF THE WEEKS TIMER
You can disable all the week timers, by pressing the
week timer button
reading in the display extinguishes. Alternatively, you
can use the week timer button
press the cancel button
be disabled by pressing the ON/OFF button
or by pressing the ON/OFF button
the display
is flashing.
B
DETECTION OF OPEN WINDOWS
These are repeated measurement cycles. Each
of them will run 10 minutes. For each cycle, the
following measurements will be made: a start
measurement, a first comparison measurement
after 5 minutes and another comparison mea-
surement after 10 minutes. If one of the two
comparison measurements is more than 8°C
.
7
and
light or blink.
A
B
are lit continuously, the selected
B
blink, it means that the selected
B
and
A
B
again, after P6 is shown. Then the
9
and then immediately
9
. The weekly timer can also
6
five times while
E
8
continue
once,
1
Advertenties
Hoofdstukken
Inhoudsopgave
