Electromagnetic Compatibility - Ktc Kane77 Handleiding
Inhoudsopgave
ELECTROMAGNETIC COMPATIBILITY
European Council Directive 89/336/EEC requires electronic equipment not to
generate electromagnetic disturbances exceeding defined levels and have
adequate immunity levels for normal operation. Specific standards applicable
to this product are stated below.
As there are electrical products in use pre-dating this Directive, they may emit
excess electromagnetic radiation levels and, occasionally, it may be
appropriate to check the monitor before use by:
Use the normal start up sequence in the location where the monitor will
be used.
Switch on all localized electrical equipment capable of causing
interference.
Check all readings are as expected. A level of disturbance is acceptable.
If not acceptable, adjust the monitor's position to minimize interference or
switch off, if possible, the offending equipment during your test.
At the time of writing this manual (February 2012) Kane International Ltd are
not aware of any field based situation where such interference has occurred
and this advice is only given to satisfy the requirements of the Directive.
This product has been tested for
compliance with the following generic
standards:
EN 61000-6-3
EN 61000-6-1
and is certified to be compliant
Specification EC/EMC/KI/KANE77 details
the specific test configuration, performance
and conditions of use.
Haarlerberg 12, 3825CD Amersfoort,
T +31(0)33 8886799, M +31(0)650 881549
info@ktc-nederland.com, www.ktc-nederland.nl
Inhoudsopgave
