Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Wall mount placement:
The Wall Mount is also the charger for N-Joy Controller. Find the most strategic place – with
regards to the range to the Bluetooth receiver - to locate the wall mount. There are 3 ways to
connect the wall mount to a power outlet:
1
Built-in: With the included adapter and USB/Micro-USB cable (300 cm):
Make sure a 5/8" electrical conduit pipe is built into the wall, ending on one side on the
spot where you wish to place the wall mount, and on the other side near a power
outlet. The length of this 5/8" tube should not exceed 250 cm. Lead the power cable
through this tube, with the Micro-USB side on the end of the wall mount. Insert the
included adapter in the power outlet and connect the USB cable to it. Connect the
Micro-USB to the back of the
place the wall mount is clean and dry. Remove the cover layer of the tape strip on the
back of the wall mount.
The wall mount is placed and ready for use.
*
Check if the wall mount functions in charging the controller before you place it on the
wall, the wall mount cannot be easily removed once attached.
2
Built-on: With the included adapter and USB/Micro-USB cable (300 cm):
The USB cable will remain visible with this method. Connect the Micro-USB to the
back of the
the USB cable to it. Make sure the surface where you will place the wall mount is
clean and dry. Remove the cover layer of the tape strip on the back of the wall mount.
Place*
and ready for use.
*
Check if the wall mount functions in charging the controller before you place it on the
wall, the wall mount cannot be easily removed once attached.
Place*
mount*. Insert the included adapter in the power outlet and connect
wall
the wall mount and press is to the wall for 5 seconds. The wall mount is placed
mount*. Make sure the surface where you will
wall
the wall mount and press it to the wall for 5 seconds.
23
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
