Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
USING YOUR DISHWASHER
Filling the rinse aid reservoir
1.
Open the reservoir cap.
2.
Carefully pour in the rinse-aid into its dispenser, whilst avoiding it to overflow.
3.
Close the reservoir cap.
Note: Clean up any spilled rinse aid with an absorbent cloth to avoid excessive foaming
during the next wash.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is designed to
adjust the consumption by the user. If the dishes are not drying properly or are spotted, select
a higher setting until your dishes are spot-free. Select a lower setting if there are sticky whitish
stains on your dishes or a bluish film on glassware or knife blades.
1.
Switch on the appliance.
2.
Within 60 seconds after step 1, touch program key > for more than 5 seconds.
3.
Touch the delay plus (+) key to enter the setting mode. The rinse aid indicator blinks.
4.
Touch the program key > to select the proper setting according to your using habits. The
settings will change in the following sequence: D1->D2->D3->D4->D5->D1. The factory
setting is D3.
5.
Press the On/Off button to confirm the setting and to end the setting mode.
Setting
D1
D2
D3
D4
D5
EN 16
Amount of rinse aid (ml)
1.2
2.4
3.6
4.8
6.0
Advertenties
Hoofdstukken
Inhoudsopgave
