Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7
troubleshooting
If your appliance is not working properly, it may be a minor problem, therefore check the following:
Problem
Appliance is not functioning; light
does not work
Temperature inside the
refrigerator is too high or too low
Water is running out of the
refrigerator
Appliance is excessively noisy
The inside light is not working
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
8
installation instructions
Before installation, read the instructions carefully.
• Fit the refrigerator/freezer in stable kitchen units only with sufficient ventilation (figure B and C).
• If necessary, reverse the door according to the instructions.
• Check the installation dimensions according to figure C. The position of the joint between the unit doors must be level with the
position of the joint between the appliance doors.
1 See figure A for the necessary attachment components.
2 Insert the trim flap
into the slot and screw by screws
1
3 Pass the power cord through the ventilation shaft and position it so that the appliance could be easily plugged in once it has
been installed (figure B and C).
4 Take out the trim gasket
appliance (figure E).
5 Raise the appliance and slide into the kitchen unit. Push the appliance to the reverse side of the door hinges providing that the
trim gasket
covers the space between the appliance and the kitchen unit.
2
6 Allign the front feet with the front surface of the kitchen unit (figure F).
7 Screw the front feet by using screws
8 Screw the trim flap
to the kitchen unit using screws
1
9 Screw the fixing bracket 11, as leaned to the kitchen unit by using screws
10 Screw the guides
to the appliance doors with screws
3
angle 90°. Slide the rails
11 Set 1-2 mm gap on the handle side between the unit itself and the unit doors by adjusting the guides
the appliances performance.
Cause
- Appliance is not plugged in
- There is a power failure
- The thermostat is set on ●
Thermostat has been set
incorrectly
Air circulation vents are blocked
Drain outlet is blocked
Has the appliance been installed
correctly?
Are the pipes at the back touch-
ing or vibrating?
Lamp is defective
located on the side panel of the appliance and stick it on the reverse side of the door hinges of the
2
(figure F).
5
into the guides
aligning the groove. Screw the rails
4
3
Solution
- Plug the appliance in
- Check the fuse box
- Set the thermostat on setting 1-5
Set the thermostat correctly
Clean the ventilation openings
Clear the drain outlet with a skewer
Check the installation
Check it and move the appliance forwards
Contact the customer service department
(figure D).
6
(figure G).
5
. Repeat this for the opposite side (figure H).
5
. Lean the appliance doors to the unit door as it is opened at the right
6
to the unit doors with screws
4
(figure J).
5
(figure J). That is vital for
3
English
•
23
Advertenties
Inhoudsopgave
