Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Connecting gas circuit to NG source
•
Keep at hand suitable crossed screwdriver, adjustable
spanners, pliers and wrenches. Before assembly, make
sure all protection packing material has been removed.
Flexible gas hose(1763-1) and clamps (if necessary) are
supplied with this appliance and must be used, according
to National Rules in force. You need to purchase one gas
regulator and one gas cylinder. The gas regulator has to
be set according to specific gas category (see on page
2) and proper gas consumption (g/h) specification. NG
source should be standard one. Replacement must be that
specified in "Gas Requirements" section of this Instruction
Manual. Be careful: do not kink flexible gas rubber pipe of
gas circuit. If pipe holder should not be provided, thread of
the gas inlet connection will be in line with Standards ISO
7-1 or ISO 228-1, according to National Rules in force of
the country of destination.
•
Make sure appliance is turned "OFF" before assembling.
•
Connect the regulator to the hose the appliance.
ENGLISH
Heater Lighting Instructions
•
Protect appliance from wind during lighting and operation.
•
TURN ON THE HEATER
1.
Turn on the gas source.
2.
Pull the red string down and 'click' will be
heard and continue to hold for 10 seconds.
The tiles should turn to red color. Release
the string.
3.
If the burner does not ignite, turn off the
gas source. Wait at least 5minutes for
gas to clear, then retry. If your heater still
fails to light, turngas source OFF. Refer
to the instruction manual "Lighting Your
Heater Using A Match" and "Trouble
Shooting" for further information.
•
TURN OFF THE HEATER
1.
Pull the black string down until 'click'
will be heard and then release. The tiles
should turn from red to black.
2.
If the heater does not turn off, repeat
step one.
3.
Turn off the gas supply.
4.
When the heater is not in use, please turn
off the gas source.
8
Check for Gas Leaks
Never test for leaks with an open flame. Prior to first
use, at the beginning of each season, or every time
your LP Gas Cylinder is changed, you must check for
gas leaks. Follow these three steps:
1.
Make a soap solution by mixing one part
liquid detergent and four parts water.
4 parts water
1 part liquid detergent
2.
Pull the black string down until 'click' will be heard
and then release, then turn on gas at source.
TURN ON(Red)
TURN OFF(Black)
3.
Apply the soap solution to all visible gas connections.
If bubbles appear in the soap solution the connections
are not properly sealed. Check each fitting and tighten
or repair as necessary.
4.
If necessary, substitute gasket (according to EN
549 Class B2) or material used to guarantee
tightness (according to EN 751-1 Class I).
NG/LPG
NG
Advertenties
Inhoudsopgave
