Before use
Unpacking
NOTES:
The 2 cooling packs
o
stored inside the water tank
The remote control
o
storage on the back of the product (Fig . G) .
1 . Remove the packaging .
2 . Check if all parts are complete .
3 . Check if the product is damaged .
Filling the water tank
Fig.
Action
D
Rotate the locking lever
90° .
Slightly pull the removable water tank
E
Fill the removable water tank
Check the water level at the water gauge
Min
–
After filling: Slide the removable water tank
o
Rotate the locking lever
o
the removable water tank .
Operation
1 . Insert 4 casters
26 ]
[
of the product (Fig . H) .
2 . Place the product on a flat, stable ground .
3 . Connect the mains plug
socket-outlet .
12 GB/IE/NI
and 4 casters
27 ]
[
[
26 ]
(Fig . G) .
25 ]
[
is stored in the handle
[
28 ]
25a ]
[
Max
mark and below the
25a ]
[
to all corners on the bottom
to a suitable
[
21 ]
Inserting/Replacing the
battery
Fig . C
are
For first time use: The button cell
o
(type CR2025) is pre-installed inside the
remote control
from the battery compartment
1 . Open the battery compartment
the battery receptacle (located at the back of
the remote control
2 . Remove the used battery, if present .
3 . Insert a button cell (type CR2025) into the
battery receptacle . The + polarity marking has
to point upwards .
4 . Slide the battery receptacle back into the
battery compartment
5 . Use a dry, lint-free cloth to clean the battery
contacts before inserting .
for the removable water tank
out of the product .
25 ]
[
with cool water .
[
25 ]
: The water level must be above the
[
36 ]
mark .
into the product .
[
25 ]
for the removable water tank
4 . Turning the product on: Press
5 . Keep the remote control
that it does not fall and break .
6 . When you are not using the remote control
Store the remote control on the handle storage
on the back of the product .
. Pull out the insulation strip
28 ]
[
.
[
32 ]
: Remove
32 ]
[
.
[
28 ]
.
[
32 ]
counter-clockwise by
[
25 ]
clockwise by 90° to lock
[
25 ]
or
15 ]
[
in a safe place so
[
28 ]
.
29 ]
[
:
28 ]
[