Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
!
Fitting the floor-tool
Lower the floor-tool by moving the release lever to the lower position (Fig.7).
Push floor-tool onto the holder and secure with the easy-fit securing pin (Fig.8).
Push floor-tool hose onto the floor-tool; ensure hose is pushed down fully (Fig.9).
Note: Raise floor-tool again before driving to the cleaning area (Fig.10).
Setting the width adjustment
450mm
550mm
Machine Set Up
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
Fig.7
Fig.8
Note: Remove the brushes before
Adjustment of the Brush deck must take place
with the deck in the raised position.
See (page 20) on lowering and raising the brush
deck.
12
!
Fig.9
Fig.10
adjusting width!
!
Advertenties
Inhoudsopgave
