Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Delete all pre-configured
channels on the wireless
flush-mount switch
All preconfigured channels can be de-
leted again.
a.) Plug the wireless flush-mount switch into a
standard 230 VAC mains voltage in the
manner indicated in the above section.
b.) Press button (2) until LED (1) flashes red.
c.) Before LED (1) stops flashing, again press
button (2) on the wireless flush-mount
switch. LED (1) will stop flashing, indicating
that the delete process has been successfully
completed
FUNCTION TEST
Plug the wireless flush-mount switch into a
suitable 230 VAC mains voltage in the man-
ner indicated in the above section. You can
check the functioning of the wireless flush-
mount switch by briefly pressing the corres-
ponding "ON" button of the relevant switch
channel. LED (1) will flash red. The switch
contact at the middle terminals is now activ-
ated and the mains voltage is connected and
an attached device will thereby also be auto-
matically switched on. Briefly press the "OFF"
button of the corresponding switch channel on
the transmitter, which will prompt LED (1) to
stop flashing, the mains voltage at the centre
terminals and the device connected to it will
be switched off.
OPERATION
Connect a device to the switch contact.
Please read the chapter titled "Technical
Details" to learn more about the max-
imum capacity of the device.
Operating the corresponding "ON" or
"OFF" button of the switch channel on the
EN
21
Advertenties
Inhoudsopgave
