Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
26
www.electrolux.com
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
8.3 Replacing the lamp
Break the circuit of the appliance.
1. Unscrew the lamp cover securing
screw.
2. Unhook the moving part by pressing it
as shown in the figure.
9. INSTALLATION
WARNING!
Refer to Safety chapters.
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
SN
N
ST
T
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
2
1
3. Replace the bulb with one of the same
power. (the maximum power is shown
on the light bulb cover)
4. Fix the lamp cover in place.
5. Screw the lamp cover securing screw.
6. Reconnect the appliance.
Open the door and check if the light
comes on.
Some functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only be
guaranteed within the
specified temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer
service or to the nearest
Service Centre
9.2 Location
It must be possible to
disconnect the appliance
from the mains power supply;
the plug must therefore be
easily accessible after
installation.
The appliance should be installed well
away from sources of heat such as
radiators, boilers, direct sunlight etc.
Ensure that air can circulate freely around
the back of the cabinet. To ensure best
performance, if the appliance is positioned
below an overhanging wall unit, the
minimum distance between the top of the
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
