BEFORE FIRST USE
Minimum pan diameter
•
The diameter of the bottom of the pan must be at least 11 cm. You will achieve the best
results by using a pan with the same diameter as the zone. If a pan is too small, the zone
will not work.
Attention
Grains of sand may cause scratches which cannot be removed. Only put pans with
a clean bottom on the hob. We recommend that you lift pans and not slide them
over the hob.
Power level setting
The cooking zones have 9 levels. Beside it there is a 'boost' level (P). Set the cooking level by
touch and slide over the slide control. At the first touch, the level is set according to the part of
the slide control that you touch. By slide over the slide control, the cooking setting is changed.
By move to the right, the level increasing, while moving to the left decreases the level. When you
move your finger away from the slide control, the cooking zone starts to operate at the level set.
Boost function
You can use the boost function to cook at the highest power level during a short period of time
(max. 5 minutes). After the maximum boost time the power will be reduced to setting 9.
Power limiter
The hob is equipped with a power limiter. If the total power of operating cooking zones exceeds
the maximum available amount of power, the power is automatically reduced. The display of the
cooking zone who is being reduced in its power is first flashing; the level is then automatically
reduced to the highest available power.
Pan detection
•
The pan detection system automatically detects a pan that is put on a cooking zone. The
display of this cooking zone lights up more intensely and the slide control appears.
•
If the hob does not detect a (ferrous) pan after a power level has been set, the pan detection
symbol flashes in the display. After 10 minutes the cooking zone switches off.
•
If you remove a pan from the cooking zone during cooking, the pan detection symbol
shows. The cooking zone switches off. The symbol disappears when you put the pan back.
The cooking zone switches on again with the power level that was set before.
EN 10