Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Warning about property damage
Only carry and transport the induction hotplate by holding it with both hands in the
holding recesses (4).
7.2 Usage
Even though the two heating zones (1 and 3) look the same and have the same
diameter, please remember that the left heating zone (1) provides higher power and
therefore the same quantity of food will heat up more quickly or the food could burn
more easily.
If you switch the induction hotplate off and the surface temperature of the heating zones
(1, 3) is higher than 60 °C, "– H –" is shown on the display (13). If the temperature
drops below 60 °C, the display (13) shows "– L –".
If you remove the pan from the induction hotplate when in use, the display (13) shows
"E0" and a beeper sounds every 2 seconds. The beeper stops sounding after approx. 60
seconds. The display (13) of the corresponding heating zone (1, 3) continues to show "–
H –" as long as the surface temperature of the heating zone (1, 3) is greater than
60 °C. If the temperature drops below 60 °C, the display (13) of the heating zone (1,
3) shows "– L –". The fan may continue to run for up to a minute.
The only way to hide the "– H –" and "– L –" symbols from the display (13) is by
disconnecting the product from the mains or by switching the induction hotplate on
again.
After switching on, the default power setting is L05 for the left heating zone (1) and L04
for the right heating zone (3).
1.
Connect the induction hotplate to a live mains socket using the power cable (2). A beeper then
sounds and the display (13) of the heating zone (1, 3) shows "– L –" or "– H –" depending on the
temperature.
2.
Place a pan on one of the heating zones (1, 3).
Place the cookware centered on the heating zone
(1, 3).
SilverCrest SDI 3500 C3
Bottom diameter 10 to 22 cm
English - 53
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
