Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The amount of wear and tear depends on the usage intensity, but
in general the components must be replaced after approximately
one year.
Press both release buttons for the shaving head
the shaving head
Press both release buttons for the shaving foil frame
the shaving foil frame
Replace the shaving foil frame
Press both release buttons for the shaving head
Hold the cutter block
pull it carefully off the razor (see Fig. G). Make sure that the
spring that is located between the cutter block
bracket does not fall out.
Hold the new cutter block
and guide it carefully into the white bracket. Push it down as far
as it will go, until it audibly clicks into place on the cutter block
mount
.
21
First put the new shaving foil frame
followed by the shaving head
Troubleshooting
Fault
No function.
Cutting performance
is deteriorating.
(see Fig. I).
4
off the product (see Fig. I).
3
with a new one.
3
between your thumb and forefinger and
20
between your thumb and forefinger
20
.
4
Possible causes
The battery may not
be charged.
Hair may be stuck in-
side the cutter block
or hair clipper
20
and pull off
5
(see Fig. I).
5
and the white
20
back on the product,
3
Action
Recharge the product.
Clean the product, as
described in the cor-
.
responding chapter.
22
and pull
2
GB/IE/NI
21
Advertenties
Hoofdstukken
Inhoudsopgave
