Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
1. Pull out the Longopac bag (A) and attach a cable tie
(B) to close the new Longopac bag.
B
2. Shake down the dust in the used Longopac bag.
3. Attach a cable tie 10 cm/3.9 in. below the first cable
tie to close the used Longopac bag. Cut off the
Longopac bag between the cable ties.
Introduction
WARNING:
occur during the troubleshooting, servicing
and maintenance as the operator must be
in the risk area of the product. The operator
must be careful, make a plan and prepare
the work to prevent accidents.
14
A
Product related accidents
4. If the remaining part of the Longopac bag cassette
is too small to prepare a new Longopac bag, install
a new Longopac bag cassette. Refer to
new Longopac bag cassette on page 12 .
5. Obey local regulations for disposal of the full
Longopac bag.
To do after completed work
1. Do the filter purge procedure. Refer to
dust particles from the prefilter during operation on
page 12 .
2. Stop the product, refer to
SH on page 11 or To start and stop DE 110 H/DE
120 H on page 11 .
3. Discard the Longopac bag. Refer to
Longopac bag and prepare a new Longopac bag on
page 13 .
4. Clean the product. Refer to
page 16 .
5. Prepare the product for transportation. Refer to
move the product long distances on page 22 .
Maintenance
To start and stop DE 110
To clean the product on
WARNING:
Before you do
maintenance, make sure that the motor
switch and the pump switch are in the Off
positions. Disconnect the power cord and
remove the pump cable.
WARNING:
Only let an approved
electrician do all checks of the electric
components.
1979 - 001 - 23.02.2023
To install a
To remove
To discard a full
To
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
