Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.1 Removing the Filter Cartridge
•
Switch off the power supply of the terminal equipment (remove plug).
•
Close the inlet valve
•
Place the flush hose in a bucket and remove pressure from the filter system by
opening the flush valve
Note: If the escaping water is more than 1 litre, the inlet value
closed or is blocked with scale.
•
•
•
•
•
Remove used filter cartridge
•
Place the used filter cartridge
drainage (> 5 min).
•
Lock the used filter cartridge
ter cartridge and return in the original packaging to the appropriate BRITA address
listed on the back of the cover.
6.2 Inserting the Filter Cartridge
•
Check the O-ring seal of the new filter cartridge
in the groove, dirt and damage. Note: The cartridge seat has been
lubricated with food-safe lubricant at the factory.
•
•
•
•
•
•
•
at the inlet hose
6
. Collect waste water in the 10L bucket.
16
Stand on the kick loops
vessel lid
by pressing the lock
3
far as it will go.
Place the pressure vessel lid
Stand on the kick loops
vessel
anti-clockwise by the mantle handles
1
Take your feet off the kick loops
down with both hands on the mantle handles
1
from the pressure vessel
2
in the sink with the connection facing down for
2
with the transport protection cap
2
Check the connector seat of the filter cartridge O-ring
pressure vessel lid
Place new filter cartridge
Stand on the kick loops
whole turning clockwise until the mantle handles
kick loops
.
9
Stand on the kick loop
vessel lid
on the pressure vessel
3
marking on the lid handle
groove.
Press the pressure vessel lid
lock engages
.
8
Switch on electrical power supply to the terminal device.
Execute the steps described under 5.3 to flush and bleed the new
filter cartridge
.
2
.
5
with both feet while opening the pressure
9
and turning it anti-clockwise as
8
vertically on the lid handle
3
with both feet while turning the pressure
9
and press the pressure vessel
9
for dirt and damage.
3
in the pressure vessel
2
with both feet; lift the pressure vessel
9
with both feet and place the pressure
9
. The positioning of the arrow
1
must line up with the "INSERT"
14
down and turn clockwise until the
3
is not completely
6
.
14
as far as it will go.
11
.
11
.
1
of the new fil-
12
for correct seat
2
in the
2
.
1
are over the
11
EN
1
17
Advertenties
Inhoudsopgave
