Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
•
Always place the appliance on a moisture-resistant and dry surface.
•
Place the appliance on a firm and flat surface (floor) so that it is stable, otherwise
vibrations and noise may occur. When placing the appliance on floor coverings
such as carpets, straw mats or polyvinyl chloride (PVC), place a solid sheet or
cover under the appliance to prevent colour change due to heat dissipation.
4. Clean
Before putting the appliance into use, clean the interior and all associated accessories
with lukewarm water and neutral soap. Dry everything carefully. Do not use solvents or
abrasive powders; these may damage the coating.
5. Wait
On first installation (or after turning the door) wait at least four hours before plugging in
the appliance. This allows the oil to flow back into the compressor.
6. Switch on
Before plugging in the power cable, check that the voltage and frequency of the type
plate match your power supply network. Only connect the appliance to an earthed
power socket. After one hour, open the door of the appliance. If the temperature in
the appliance is noticeably lower, this indicates that the cooling system is operating
normally.
7. Mounting accessories
- Adjustable shelves
The walls of the appliance are equipped with a series of guide profiles so that the
shelves can be inserted if desired.
- Installing the door compartments
To store food of different sizes, the door compartments can be set to different
heights. Proceed as follows: gradually pull the compartment in the direction of the
arrows until it comes loose and put it in the desired position.
8. Storing food
See Section 4 "Use".
29
Advertenties
Hoofdstukken
Inhoudsopgave
