Advertenties
Beschikbare talen
Beschikbare talen
4.3 Accessories Installation
Anti-vibration bases
1. Take out 4 Anti-vibration bases
2. Install them on the bottom of
machine.
Draining plug
1. Install the draining plug under the
bottom panel
2. Connect with a water pipe to drain
out the water.
Note: Lift the heat pump to install
the. Never overturn the heat pump, it
could damage the compressor.
Water Inlet & outlet connection
1. Install the two joints like the
picture shows
2. Screw them onto the water Inlet &
outlet connection
Mains Cable wiring
1. Open the cover of the terminal box
(marked red) on the side of machine
2.Tight the cables in the correct
connections, L N E, inside the
terminal block.
Filtration
pump
wiring
(Dry
contact)
1. Open the cover of the terminal box
(marked red) on the side of machine
2. Tight the cables in the correct
connections, 1 2, inside the terminal
block.
18
Advertenties
