Measurements - Condtrol Hydro Pro Gebruiksaanwijzing
Vochtmeter voor hout en beton
Inhoudsopgave
WOOD AND CONCRETE
EN
MOISTURE METER
MEASUREMENTS
Single measurement
Press
Press
Press
Press
and
Press
HYDRO PRO CONDTROL
Switch on the device.
Perform zero calibration (check paragraph «Zero
calibration»)
Select the material (wood; concrete)
Select the group of measured material
Select the sensor (front; bottom 15 mm; bottom
30mm)
To obtain reliable measurement results, it is
necessary to ensure proper contact of the
sensor with the surface (there should be no
gaps between the sensor and the surface) and
check the measurement result on the display.
Tested surface should be smooth and clean, as
homogeneous as possible, without deep dents
and protrusions. The sensor should be pressed
with a force of about 1kg.
The result of humidity measurement of the site
(sample) is:
* for wood - the average value of at least three
measurements
* for concrete - average value of no less than five
measurements
User manual
11
11
Inhoudsopgave
