Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ACO203 / ACO203 BT / ECO203
7.5 Battery (ACO203 / ACO203 BT only)
EN
Removing the battery (Fig. 2)
Push in (1) the two release buttons (A) and then remove the battery (2).
Inserting the battery (Fig. 3)
Slide the battery into the device as illustrated until it clicks into place.
Battery charge indicator (Fig. 2)
The battery charge is displayed when button (B) is pressed. The number of LEDs lit up denotes the
battery charge. One flashing LED indicates a maximum power reserve of 10%. The battery must be
charged soon.
If the battery is inserted in the press device while the battery charge is being checked, the last
pressing operation must have been completed at least 1 minute prior to this. Otherwise the display will
be inaccurate.
Feature of the press device when the battery is empty:
When a pressing operation begins, a check is made to determine whether the battery charge is
sufficient to complete the pressing operation. If this is not the case the device does not start. The
green LED (2) flashes.
If the green LED (2) flashes following a pressing operation, the pressing operation was carried out
correctly. The battery must be recharged prior to the next pressing operation.
7.6 Energy saving mode
If the press device is not used over an extended period, the device switches off. No LED is lit up any
longer. Press the start button (1) briefly to activate the press device.
Information!
The batteries are not charged at the factory.
Therefore:
–
Charge the batteries before using for the first time.
Information!
Limited temperature range for charging and storing the batteries.
Therefore:
–
It is imperative that the operating instructions for the battery charger are complied
with.
Information!
The ACO203 / ACO203 BT press device must only be operated with 18 V
rechargeable lithium-ion batteries. The rechargeable 18 V battery must only be
used in the appropriate press devices.
18
Advertenties
Hoofdstukken
Inhoudsopgave
