Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
BP-GIKLED08
5.2. How to Use
5.3. Sticky Pads
6. Troubleshooting
P-GIKLED08.indd 5
Keep the insect killer working for 3 hours before going to sleep. Make sure to keep
windows and doors closed.
1.
Connect the insect killer to a 5 V power supply. Install the insect killer in a dry
location on a stable and non-slippery surface.
2.
Slightly press the on-off button to start the insect killer.
3.
Press the same button to stop the insect killer. Disconnect from the power
supply after use.
For best results, turn off other light sources and prevent from installing the
appliance in the draught.
1.
Switch of the appliance and disconnect from the mains.
2.
Remove the protective layer of the sticky pad.
3.
Apply it at the bottom of the storage tray. Replace when covered with bugs.
4.
Close the tray and reconnect the appliance to the mains.
Problem
Appliance does not start
Appliance does not light
Noisy fan
Reason
Power supply not
connected well
On-off button not pressed
Power supply not
connected well
Light is damaged
PCB board is damaged
Foreign objects in the fan
5
Possible solution
Reconnect the power
supply
Press the on-off button
Reconnect the power
supply
Light source cannot
be replaced; scrap the
appliance
PCB Board cannot be
replaced; scrap the
appliance
Clean the fan
12/01/2021 15:37:12
Advertenties
Inhoudsopgave
