Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
UK
8.
Display Error Codes
Please contact your local distributor if any of the error codes below appears.
Code
E1
E2
L3
L4
9.
Trouble Shooting
Check the following before contacting technical support .
PROBLEM
The device does
not work
Water removal ca-
pacity is too low
The device works,
but reduces the
relative humidity
insufficiently
82
Error
Temperature sensor
error
Humidity sensor error
Air inlet temperature
is too
high >42ºC
Air inlet temperature is
too low >0ºC
POSSIBLE CAUSE
The power is not connected
The water tank is full
The tank has not been replaced
correctly
Runtime is too short
Ambient temperature or humidi-
ty is too low
The room is too big
There is too much ventilation
The air filter is clogged
Set humidity is higher than the
ambient humidity
MV-2502-2508-03-2024 . eeese-aircare.com © All rights reserved eeese air care ApS
Display
Flash every 30
seconds
Flash every 30
seconds
Slowly flash L3
Slowly flash L4
What is happening
Device still dehumidifies but is
in defrost mode only.
Device still dehumidifies but
is in continuous dehumidifying
mode only.
Compressor stop working, fan
works at low fan speed. 10mins
later, if the temperature decrea-
se to below 40 machine will
work normally.
Compressor stop working,
fan works at low fan speed.
10mins later, if the
temperature increase to
above 2 machine will
work normally.
SOLUTION
Insert the plug into the wall
outlet
Empty the tank
Replace the tank
Be patient and wait
It is normal that the device
does not dehumidify in these
conditions
We recommend using a dehu-
midifier with a greater capacity
Reduce ventilation (e.g. close
windows and shut doors)
Clean the air filter
Set the humidity lower than
ambient humidity
Advertenties
Hoofdstukken
Inhoudsopgave
