LUND 67950 Oorspronkelijke Gebruiksaanwijzing pagina 13
Inhoudsopgave
Beschikbare talen
Beschikbare talen
GB
the plug from the power socket. Avoid any contact between the power cord and heat sourc-
es, oil, sharp edges, and moving parts. Damage to the power cord increases the risk of an
electric shock. If the power cord is damaged (e.g. it is cut or its insulation is melted), imme-
diately unplug it from the wall socket and return it to an authorised service facility. It is not
allowed to use the product with a damaged power cord. It is not allowed to have the power
cord repaired. It must be changed for a new one at an authorized service centre. When using
extension cords, use extension cords with power parameters such as those shown on the
appliance's nameplate. The cross-section of the extension wires shall not be less than the
cross-section of the wires of the power cord of the appliance. This should be checked on
the insulation of the power cord and the extension cord, or contact the manufacturer of the
appliance and/or the extension cord.
Do not use the appliance with damaged equipment parts If you notice any damage to any
part of the appliance or accessory, you must discontinue using it. In this case, the appliance
must be taken to an authorised service centre or replaced by yourself, if this is permitted by
the user's manual.
Turn off the appliance and unplug the power cord from the wall socket before you start any
work on replacing, cleaning, or adjusting moving parts.
The appliance must not be used by children. This appliance may be used by persons with
reduced physical, mental abilities and persons with no experience or knowledge of the ap-
pliance, if supervised or instructed on its safe use so that the risks associated with it were
understandable. Children should not play with the appliance. Unattended children should not
be allowed to perform the cleaning and maintenance of the appliance.
The appliance contains sharp parts (blender blade, mill blade, chopping blade, grater blades)
and special care should be taken when assembling, disassembling and cleaning such parts.
The appliance is intended for home use only. It is recommended not to exceed 6 minutes
of continuous operation, after which the appliance should be left to cool down for about 20
minutes . During cool-down, unplug the power cord from the power socket.
APPLIANCE OPERATION
CAUTION! Turn off the appliance and unplug the power cord from the socket during all equipment assembly and disassembly
activities.
Preparing for operation
Remove the product from its packaging, remove all parts and then wash all parts in contact with the food according to the instruc-
tions in the section entitled "Product maintenance".
Mixer assembly and disassembly
Place the drive housing on level and stable surface. Make sure that all suction cups in the base have attached themselves to the surface.
Place the mixer bowl on top of the drive housing so that the bowl's bottom edge is fully fl ush with the drive housing wall along
the entire circumference and the marker at the bottom edge of the bowl points to the open padlock symbol (X), and then rotate
the bowl so that the marker points to the closed padlock symbol (XI). The correctly installed bowl's lower edge is fl ush with the
entire circumference of the upper wall of the drive housing. A correctly mounted bowl cannot be dismantled except by turning it, so
that the marker indicates the open padlock symbol, and lifting. The drive housing has a safety device which, in case of improper
installation, will not allow to start the appliance rotation.
Place the spindle on the drive shaft inside the bowl (IV).
One of the following accessories can be attached to the spindle as required: grater holder with mounted grater, chopping blade,
kneading stirrer or whisker disc (V).
The grater must be mounted in the holder in such a manner that the hook at the rounded edge of the grater hits the gap in the
holder, and the axis of the holder passes through the opening in the grater (VI). Then press the grater into the holder so that the
O R I G I N A L
I N S T R U C T I O N S
13
Inhoudsopgave
