Re-Assigning The Remote Control; Testing Automatic Flush Actuation - Geberit AQUACLEAN SELA Installatiehandleiding
Verberg thumbnails
Zie ook voor AQUACLEAN SELA:
- Gebruiksaanwijzing (73 pagina's) ,
- Handleiding (13 pagina's) ,
- Gebruiksaanwijzing (24 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Re-assigning the remote control
The device can only be operated with a
single, assigned remote control.
Prerequisite
– The device is switched off.
▶
Switch the device on and, at the same time,
press the <+> button on the remote control
for approx. 30 seconds until [Pairing ok]
appears on the display.
Result
✓ The shower toilet can be controlled by remote
control.
34
Testing automatic flush actuation
The following test must only be performed if the
device is fitted with the optional interface module for
flush actuation (art. no. 147.039.00.1).
Prerequisite
– The automatic flush actuation has been fully
installed.
– The automatic flush actuation has been
switched on in the main menu [Basic settings].
– All plug connections are connected correctly.
▶
Apply a load to the WC seat ring for more
than 10 s econds. Then remove the load.
Result
✓ A flush is actuated after around 5 s econds.
45035999965553803-1 © 02-2019
970.057.00.1(00)
Advertenties
Inhoudsopgave
