Inhoudsopgave
Advertenties
see the
"Technical menu
Batteries: preparation
vided with the necessary personal protection devices (gloves, goggles overalls, etc.) to limit
If the batteries are dry, proceed as follows before installing them in the machine.
plates are entirely covered (this requires at least a couple of passes for each element).
Leave the batteries stand for 4-5 hours to allow air bubbles to come to the surface and the plates
to absorb the electrolyte.
Make sure the level of electrolyte is still above the plates and if necessary top up with sulphuric
acid solution.
Close the caps.
Install the batteries in the machine (following the procedure described below).
"Battery maintenance and
Batteries: installation and connection
Referring to the cable layout shown in the above diagram, connect the battery cables and bridge
terminals to the battery poles. Arrange the cables as shown in the diagram, tighten the terminals on
the poles and coat with Vaseline.
Lower the tank into the working position.
When using the machine, follow the instructions below.
2
Battery
-
+
! IMPORTANT!
installed:
section".
! DANGER!
sparks and do not smoke.
charging" section.
! DANGER!
cause them to explode.
! WARNING!
3
EN
-
Battery
15
Advertenties
Inhoudsopgave
