Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Do not store the mower in damp rooms.
For safety reasons, replace worn or damaged parts.
Use only original WOLF spare parts, otherwise there is no gua-
rantee that your mower complies with the safety regulations.
Assembly
Fixing the grab handle
1
Caution!
When collapsing and unfolding the grab handle, the cable
could be damaged.
Take care that you do not kink the cable.
See illustrations for assembly
Operation
Operating times
Please observe the regional regulations.
Request the operating times from your local authorities.
Insert the cable into the tension relief unit
Please insert the cable into the tension relief unit in accor-
dance with the illustrations
Fit the collecting basket
1
Caution! Rotating cutters
Settings only to be carried out on the mower with the motor
switched off and with the blades at a standstill.
Only insert the collection basket when your feet are at a
safe distance from the blades.
1. Lift the protection cover.
2. Hang the collection basket in the notches in the chassis (see
arrow) using the hooks.
3. Apply the protection cover.
Setting the cutting height
1
Caution! Rotating cutters
Settings only to be carried out on the mower with the motor
switched off and with the blades at a standstill.
switch the motor off and pull the plug out from the mains.
Unscrew the wheels and set to the correct height
The wheels must all be at the same cutting height setting!
Cutting height– Grass condition
Mow when the lawn is dry if possible, to protect the turf. If the
lawn is wet and the grass is long, it may be better to mow with
a higher cutting height.
12
All manuals and user guides at all-guides.com
A
B C
D
.
F
.
G
H
.
Disposal
Electrical equipment must not be placed in the hou-
sehold waste. The unit, accessories and packing
material should be taken to an environment-friend-
ly recycling unit.
Fitting the collecting basket
1. Insert the projections of the collecting basket upper section
into the openings in the collecting basket lower section.
2. Push the collecting basket upper section evenly onto the coll-
ecting basket lower section. The collecting basket is securely
located as soon as it clicks in position.
Connection to the plug socket (230 Volt, 50 Hz)
Only connect the mower to plug sockets having a 16 Amp.
fuse (slow acting) (or LS Switch Type B).
3
Note: Residual current protection device
These protection devices protect against serious injury
when touching damaged wires, insulation faults and in cer-
tain cases also when damaging wires under potential.
We recommend that the mower only be connected to
plug sockets which are protected by a residual current
protection device (RCD) having a residual current of no
more than 30 mA.
There are retro-fitting sets for older installations. Consult
your specialist electrician.
Switching the mower on/off
Switch the mower on when standing on level ground.
Not in long grass– or tilt if necessary
Motor on
K
1. Push button (1) and hold it down.
2. Pull the bracket (2).
3. Release the button (1).
Motor off
K
Release the bracket (2).
Tips for mowing
In order to prevent stripes on the lawn, always overlap the
tracks of the cut by a few centimetres
Always lay the cable securely on the terrace, paths or grass
which has already been cut.
E
J
.
L:
.
G
Advertenties
Hoofdstukken
Inhoudsopgave
