Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Troubleshooting
Problem
Lithium Jump Starter will not switch OFF when
pressing the Power Button (3)
The Lithium Jump Starter will not switch ON when
pressing the Power Button
During charging, the Lithium Jump Starter stops
charging and begins beeping
The Lithium Polymer Battery Pack becomes hot to touch
during use/begins to swell
16
Possible cause
The automatic switch off
The Lithium Polymer Battery Pack (1) has
no charge
There is a problem with the charging
procedure; the Lithium Polymer Battery Pack
has detected a problem
The Lithium Polymer Battery Pack is faulty
Solution
Leave the device unplugged from cables and all other devices for approximately 10 seconds,
and the unit should switch off automatically
Charge the unit from a power supply into the Quick Charge Input Port (4). If after charging
the device does not switch on, it may have reached the end of the battery life and will need
to be disposed of in accordance with local authorities (see 'Disposal')
1. Press and hold the Power Button for 10–30 seconds to force the continuation of charging
and possibly correct the charging issue
2. After pressing and holding the Power Button, disconnect the power supply and allow the
Lithium Jump Starter to reset
3. Reconnect the power supply to the Lithium Jump Starter to see if the unit will charge
again normally
4. If the unit again discontinues charging and begins beeping, IMMEDIATELY DISCONNECT
the power supply and discontinue use. Consult an authorised Silverline technician
Note: After pressing and holding the Power Button during this process, the LED Light (5) will
come on, which is normal. After disconnecting the charger, the LED Light may be turned OFF
(see 'Using the Torch/Strobe/SOS LEDs') before reconnecting the charger
IMMEDIATELY DISCONNECT the power supply/cables and discontinue use. Consult an
authorised Silverline technician
Advertenties
Inhoudsopgave
