Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Cleaning, Care & Maintenance
If grease is permitted to accumulate, it will begin to carbonise into a hard substance that is extremely
difficult to remove. To prevent this, follow the cleaning steps below:
•
Always turn OFF the appliance and disconnect from the power supply before cleaning.
•
Allow the appliance to cool before cleaning, but for best results clean the plates when they are still
slightly warm.
•
Use warm, soapy water and a damp cloth to clean the exterior of the appliance.
•
Take care when using scrapers to remove cooking residues as they can damage the cooking surface.
•
Dry thoroughly after cleaning.
Scraping
•
After each use, scrape the appliance with a scraper/grill stone/copper brush or flexible spatula to
remove excess fat and food. A waste tray is provided for the scrapings if necessary.
•
If there is an accumulation of burned fat or food, the cooking surface should be thoroughly scoured
and re-seasoned.
Note: It is vital that the cooking surface is re-seasoned after scouring.
Warning: Do not use steel wool as it may leave shards that could Contaminate food.
Waste tray
•
This appliance features a waste tray to collect any liquid or fats that run off during cooking
•
At least once a day, remove and empty the waste tray before washing with warm, soapy water.
•
Do not allow the tray to overfill, or excess grease will run out of the overflow hole at the front of the
tray.
Warning: Do not remove the tray during or immediately after use as the contents will be hot.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
Appliance not
The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Appliance does
Faulty thermostat
not reach set
Faulty element
temperature
Appliance heats up
Indicator light has expired
but indicator light
does not come on
Power indicator
Faulty element
light comes on but
Faulty thermostat
appliance does not
Thermostat set incorrectly
heat up
Appliance slow to
Cooking surface not cleaned
heat up
Faulty element
No power
Thermal cut-out switch is
activated
6
CU607-CU613_ML_A5_v1_20241115.indb 6
CU607-CU613_ML_A5_v1_20241115.indb 6
Probable Cause
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the plug fuse
Check mains power supply
Replace the thermostat
Replace the element
Replace the indicator light
Replace the element
Replace the thermostat
Check thermostat
Clean cooking surface as instructed
Replace the element
Check the appliance is safe with no obvious
damage then press the reset switch on the rear
Solution
2024/11/15 14:18
2024/11/15 14:18
Advertenties
Inhoudsopgave
