Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
PRODUCT MAINTENANCE
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
2
AUTO
Turn off and unplug
Locate Auto-start
shredder
infrared sensor
OILING SHREDDER
noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you
empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
PREVENTIVE MAINTENANCE & ACCESSORIES
TROUBLESHOOTING
Door Open Indicator: The shredder will not run if the cabinet door is open. When illuminated, close the door to resume shredding.
Remove Paper Indicator: When illuminated, press reverse (
SafeSense
®
Indicator: If hands are too close to the paper entry, the SafeSense
is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding.
Self Cleaning Cycle: Shredder periodically cycles in forward and reverse lasting 3-6 seconds (225Ci only).
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
4
All manuals and user guides at all-guides.com
.
3
Dip cotton swab in
rubbing alcohol
AUTO
) and remove paper.
4
away any contamination
from the paper sensors
®
indicator will illuminate and the shredder will stop shredding. If SafeSense
ENGLISH
Models 225Ci/225i
®
Advertenties
Inhoudsopgave
