Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
appropriately. Risk of injury exist if assembled
incorrectly. Damage part can effect safety and
function.
CAUTION! Be sure to place the product on
solid, even surface providing a solid footing.
Check the stability before use.
Protect the product from strong wind and storms.
Place the product in a place that is sheltered
from the wind.
Loads must be applied evenly to the product to
prevent it from tipping up.
Take care not to exceed the maximum
weight of 40 kg, otherwise this may
result in a risk of injury or damage
to the product. Otherwise this may result in a
risk of injury or damage to the product.
Assembly
We recommended that two person to assembly
the product together in order to avoid injuries or
damage to people or the product.
Connecting long side panel
panel
and bottom panel
2
nuts and washers
(see fig A). Place the pro-
7
vided screw through the insert hole. Insert pro-
vided washer onto the screw from the opposite
side of the insert hole. Then thread the acorn
nut onto the screw. Tighten with the two span-
ners provided until a snug fit.
Note: Bottom panel
3
top of the inner edge of side panels
Install the legs
with screws, nuts and wash-
4
ers
(see fig B). Place the provided screw
7
through the insert hole. Insert provided washer
onto the screw from the opposite side of the in-
sert hole. Then thread the acorn nut onto the
screw. Tighten with the two spanners provided
until a snug fit.
Bend the corner parts
5
Insert the bent corner parts
of raised bed. Then fix it with screws, nuts and
washers
(see fig C). Place the provided
7
screw through the insert hole. Insert provided
washer onto the screw from the opposite side
of the insert hole. Then thread the acorn nut
, short side
1
using screws,
3
must be placed on
.
1 2
into a right angle.
on the corners
5
onto the screw. Tighten with the two spanners
provided until a snug fit.
Bend the bottom part
edge of the side panels
Insert the plastic foot
fig D).
Clean and care
Allow all parts to dry well before packing up
the product. This will prevent mold, odors and
discoloration.
Use a moist, lint-free cloth to clean and care for
the product.
Disposal
The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
Contact your local refuse disposal
authority for more details of how to
dispose of your worn-out product.
Service
Service Great Britain
Tel.:
08000569216
E-Mail: owim@lidl.co.uk
Service Ireland
Tel.:
1800 200736
E-Mail: owim@lidl.ie
corner parts into the
5
(see fig D).
1 2
onto the legs
(see
6
4
GB/IE
9
Advertenties
Inhoudsopgave
