VEVOR MINIB Handleiding pagina 10
Warmte persmachine
Inhoudsopgave
Beschikbare talen
Beschikbare talen
1. Press machine did not make full contact with the base material. This could
be because of seams, zippers or anything else that will cause you to not have a
flat surface.
2. Verify that your Press machine is set to the recommended settings.
3. Be sure heat has been applied to both the front and the back of the design
for the recommended time.
4. Re-touch the front and back of material with heat for an additional 10-15
seconds.
Q: The Press Machine temperature goes down when I apply it to the image. Is
this something wrong?
A: Press temperature may fluctuate briefly when
placed on the base material after heating. This is due to the difference in
temperature of the heated plate and the base material.
Don't worry, the Machine temperature will quickly return to the selected setting.
Your image adhesion will not be affected.
Q: My machine keeps turning off, and I have to turn it back on. Why?
A: This is the auto-shut off safety feature of Heat Press Machine. After 10
minutes of inactivity, or no button pushes, the device will alert you and then
shut off.
- 9 -
Inhoudsopgave
