Servicing; Overheating Guard; Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - Einhell Fw 400/1 Originele Handleiding
Inhoudsopgave
Anleitung_FW_400_1_SPK7__ 14.03.14 10:47 Seite 11
7. Operation
Important! Before using the appliance for the first
time, check that the voltage supply is the same as
the voltage details set out on the data plate. Read
safety instructions listed under section 1.
When the heater is used for the first time or after a
long period of rest it may emit an odor for a short
time. This is not a fault. To totally shut down the
antifreeze heater with thermostat you must pull the
power plug.
7.1 Thermostat control/Room thermostat
(Fig. 1 / Item 2):
Switch on the required heating output. Turn the
control to "MAX" until the required room temperature
has been reached. Then turn down the control until
you hear a clear click. The thermostat control will
switch the radiator on and off automatically to
maintain the room temperature at an almost constant
level. However, this presupposes that the radiator
has sufficient output to cover the heating
requirements for the room.
Turn the controller all the way to the left = antifreeze
setting (approx. 5°C to 8°C) The device automatically
switches itself on or off.
7.2 Overheating guard
In case of excessive heating, the heating function
shuts down automatically. If this occurs, turn off the
appliance, disconnect the mains plug and wait a few
minutes for the appliance to cool. After eliminating
the cause (e.g. a covered air grille), the appliance
can be switched on again. If the overheating guard
triggers repeatedly, please contact your customer
service center (in Germany ISC GmbH).
8. Cleaning, maintenance and ordering
of spare parts
8.1 Cleaning
Danger!
Before carrying out any cleaning and maintenance
n
work the appliance must be turned off,
disconnected from the power supply and cooled
down.
Maintenance and repair work may only be carried
n
out by an electrical servicing contractor or your
customer service center.
Check the mains lead at regular intervals for signs
n
of defects or damage. A damaged mains lead may
only be replaced by an electrician or the customer
All manuals and user guides at all-guides.com
n
n
8.2 Servicing
n
8.3. Ordering spare parts
Please provide the following information on all orders
for spare parts:
n
n
n
n
For our latest prices and information please go to
www.isc-gmbh.info
9. Storage
Store the equipment and accessories in a dark and
dry place at above freezing temperature. The ideal
storage temperature is between 5 and 30 °C. Store
the electric tool in its original packaging.
10. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
service responsible for your country in compliance
with the relevant regulations.
Use a damp cloth to clean the casing.
Remove dust pollution with a vacuum cleaner.
There are no parts inside the equipment which
require additional maintenance.
Model/type of the equipment
Article number of the equipment
ID number of the equipment
Part number of the required spare part
GB
11
Inhoudsopgave
