Appliance Description; Before First Use - Inventum Akb6000Rvs Handleiding

Blokschouwkap

Inhoudsopgave

Beschikbare talen

appliance description

1. Chimney

2. Cooker hood

3. Controls

4. Metal grease filters - 2

5. Lighting

(LED spots 2 x 1.5W)

6. Carbon filter

7. Kit for recirculation

before the first use

Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the

packaging material. Keep the material (plastic, polystyrene and cardboard) out of reach of children. Check the appliance

after unpacking for any damage, possible from transportation. Place the appliance on a flat and stable surface.

This appliance should be installed and connected to the power supply by a recognized fitter who is familiar with, and works

according to the correct safety regulations.

How to install the appliance, is instructed in the installation instructions (chapter 7).

The appliance must be connected with a properly installed fused socket. The power supply (AC) and voltage at the

operating point must correspond with the details on the rating label of the appliance.

EXTRACTION SYSTEM

This cooker hood can be connected in two ways: to a duct or as a recirculation hood. Install the cooker hood according to

the instructions depending on your choice.

VENT OUTSIDE - to a duct, the cooking vapours extracted by suction are

carried outside, once the grease particles have been filtered. This is the

best method.

RECIRCULATE - as a recirculation hood, the grease particles and the

smell in the extracted vapours are filtered. The air that has been sucked in

is not carried outside but recirculates in the kitchen. You must place the

carbon filter in the shaft behind the grease filters.

Attention! The carbon filter is included. You can order this separately.

Order the accessory at your supplier or at the Inventum spare parts webshop,

www.inventum.eu

English •

Inhoudsopgave