Getting Started With Your Alcora; Adjusting The Headband; Charging The Headphones; Active Noise Cancelling Mode - Altec Lansing Alcora Handleiding
Inhoudsopgave
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
8. Volume + / – wheel (For Bluetooth, Noise Cancelling or Wired)
9. Noise cancelling ON/OFF Button
10. Noise Cancelling LED Indicator
Getting Started with your ALCORA
To use your headphones, please follow the steps below:
c) Ensure the headphones are fully charged
d) Pair your charged Bluetooth headphone a Bluetooth-enabled device prior to first use. Please
fully charge the headphones before first use.
Adjusting the Headband:
• In order to achieve maximum comfort and noise cancellation, the headband should be adjusted
to properly fit your head with the ear cups sitting comfortably over your ears.
Charging the Headphones:
Prior to use, charge your ALCORA headphone unit by connecting the included charging cable into
a USB power outlet (such as USB chargers or computer USB ports) and plug the other end into the
headphone's micro USB charging port. The LED indicator (7) will light up red showing that the unit
is being charged. When charging is complete, the red LED indicator will turn off.
Active Noise Cancelling Mode:
• Adjust the volume on the headphones by sliding the volume wheel.
• To power ON the noise cancelling function, set the ON/OFF switch to ON position. The Noise
Cancelling LED indicator will light up in blue.
Note: After you turn ON the power, you might hear a slight hissing noise. This is a normal
function and will cease after a few seconds
• When the batteries are running low, the Noise Cancelling LED indicator will become dim.
Turn the noise canceling function OFF to extend battery life. In quiet environments where noise
Inhoudsopgave
