Parkside 336770 2001 Bedienings- En Veiligheidsinstructies pagina 29
Beschikbare talen
Beschikbare talen
Mounting the magnifying glass
Insert the ball joint
and tighten the fastening screw
clockwise (Fig. A).
Push the fixing clamp
set the desired height. Tighten the fastening screw
turning it clockwise.
Placement of the base (Figure D)
The soldering iron holder
right or left side on base
as an option for left or right-handed user.
The soldering iron holder
correct position to rear side of the base
Figure D in order to prevent restriction on use of the preci-
sion engineer's LED magnifying glass
and alligator clips
Mount the base plate (Figure E)
Screw the base plate
provided, as shown in Figure E. Use a suitable screw-
26
driver (not included).
into the corresponding recess
5
6
on to the mounting rod
7
could be installed on either
13
with screwdriver (not included)
14
should be adjusted the
13
.
18
to the base
25
for the ball joint
10
as shown in
14
, fixing clamp
1
using the screws
14
GB/IE
5
and
by
8
11
29
