Powerplus POWEW67912 Handleiding pagina 26
Verberg thumbnails
Zie ook voor POWEW67912:
- Gebruiksaanwijzing (8 pagina's) ,
- Gebruiksaanwijzing (8 pagina's)
Beschikbare talen
Beschikbare talen
12 TROUBLESHOOTING
Incidents
Pump does not start
No flow
Pump does not switch
off
Insufficient flow
Pump switches off
after short operating
period
13 STORAGE
▪
Thoroughly clean the whole machine and its accessories.
▪
Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.
▪
Protect it from exposure to direct sunlight. Keep it in the dark, if possible.
▪
Don't keep it in plastic bags to avoid humidity build-up.
Copyright © 2024 VARO NV
POWEW67912
Causes
-No mains supply
-Floater does not switch
-Inlet sieve is clogged
-Pressure hose in bent
- Floater cannot sink down
-Inlet sieve is clogged
-Reduced pumping capacity
by dirty and abrasive water
-Thermal cutout stops pumps
due to dirty water
-Water too hot. Thermal-
cutout stops pump
P a g e
Remedies
-Check mains supply
-Bring floater in a higher
position
-Clean inlet sieve water jet
-Reset hose
- Place pump properly on shaft
ground
-Clean inlet sieve
-Clean pump and replace worn-
out parts
-Remove mains plug. Clean
pump and shaft
-Make sure that a water tem-
perature of max. 35°C is not
exceed
| 6
EN
www.varo.com
