Mesko MS4485 Gebruikershandleiding pagina 5
13. Do not use the device with a damaged power cord or if it has been dropped or
damaged in any other way or malfunctions. Do not repair the device yourself, as there
is a risk of electrocution. Return a damaged device to a competent service center for
inspection or repair. Any repairs may be made only by authorized service centers.
Improper repair may cause serious danger
14. Place the appliance on a cool stable, level surface, away from hot kitchen
appliances such as an electric stove, gas burner, etc....
15. Do not use the device near flammable materials.
16. The power cord must not hang over the edge of the table or touch hot surfaces.
17. Do not leave the device plugged into an outlet unattended.
18. Do not use the egg cooker if it is not filled with water.
19. The product is intended only for cooking eggs.
20. Do not pour less or more water into the tray than the graduation on the measuring
cup.
21. For additional protection, it is advisable to install in the electrical circuit, a residual
current device (RCD) with a rated residual current of not more than 30 mA. In this
regard, consult a specialist electrician.
22. Always take special care when boiling water in the kettle. Do not
23. Allow the appliance to cool for 30 minutes before using it again.
24. Only carry the kettle by holding the handle.
25.The appliance is not designed for use with external timers or a separate remote
control system.
26. The appliance must not be moved or moved if it is filled with hot water or steam.
27. After turning off the unit, unplug the power cord from the outlet and let the
equipment cool down before cleaning or storing it. Allow a sufficiently long period of
time, as a heated appliance cools down slowly.
DEVICE DESCRIPTION (Fig. A)
1. Steam opening
3. Egg tray (up to 3 eggs) 4. Graduated measuring cup
5. Egg pricker
7. Body
9. Water tray
USE OF THE DEVICE
Up to 3 eggs can be cooked simultaneously. Depending on the amount of water, eggs can be cooked hard (hard), medium
(medium) and soft (soft) .
1.Fill the measuring cup (4) with water to the mark of the desired degree of hardness and the number of eggs. Transfer the water to
the tray (9).
2.Prick the rounded end of the egg with the egg pricker (5) and place it on the tray (3) with the pricker facing up.
2. Lid
6. On/off switch with LED
8. Power cord
10. Handle
4
