Decalcifying - Cloer 4959 Handleiding
Inhoudsopgave
Beschikbare talen
Beschikbare talen
overheating protection device
The electric kettle is equipped with a over-
heating protection. In the event that you ac-
cidentally operate the electric kettle without
water, the device will automatically switch
off for your safety and can have no function for
a short time. Let the appliance allow to cool for
ca. 1 hour. Afterwards fill in cold water and the
device will be ready to operate again.
Cleaning
·
CAUTIoN: Do not immerse appliance or base in
water and do not clean under running water!
·
Do not clean the electric kettle with heavily
abrasive cleaners. They could scratch the appli-
ance.
·
Clean very dirty appliances with a damp cloth
and lukewarm water.
Removing / cleaning the lime
filter
·
The lime filter is located below the pouring
spout inside of the kettle.
·
To remove, press the upper flat edge with
your thumbs to release the two brackets. Then
remove the filter towards the top.
·
Clean the lime filter with a little bit of soapy wa-
ter and place it into the bottom hole of the scale
filter holder of the water boiler with the bottom
pin first. Then push the two upper filter hooks
back into the square holes of the holder in the
water boiler until the scale filter latches.
Decalcifying
·
If you have hard water, the electric kettle should
be decalcified regularly (depending on the
hardness of the water, about every 2 - 3 weeks).
·
Use a commercially available liquid decalcifying
product (do not use chemical decalcifiers) and
follow the manufacturer's instructions.
·
TIp: Mild calcium deposits can also be removed
with a mixture of 5 to 6 tablespoons of vinegar
in 0.5 l of water.
please observe the following when decalci-
fying the machine:
·
First, pour cold water into the electric kettle.
·
Briefly bring it to a boil.
·
Now, add the decalcifier and let the device
stand for a while.
·
CAUTIoN: Do not bring this mixture to a boil.
·
After decalcifying, rinse the pot twice with clear
water.
·
Do not clean the electric kettle with heavily
abrasive cleaners. They could scratch the appli-
ance.
·
NoTE: Regularly decalcifying your electric kettle
will reduce the electricity used and prolong the
life of the appliance. The calcium content of
water varies from region to region. Please con-
sult your local water works or utility works for
information on water hardness.
In the event of malfunctions due to calcium
deposits, the guarantee will be voided!
All manuals and user guides at all-guides.com
problem / Cause / Solution
problem
possible
cause
Electric kettle
Appliance
does not
is not
function
plugged in
Electric kettle
Overheating
does not
protection
function
switches off
appliance
Water bub-
Too much
bles over in
water has
the electric
been added
kettle
Electric kettle
Added to
does not
little watter
switch off
Electric kettle
Too much
makes loud
calcification
noises during
inside the
operation or
electric kettle
White spots
Too much
form at the
calcification
bottom of
inside the
the electric
electric kettle
kettle
Environmentally friendly disposal
We use only environmentally friendly packaging
for the transport of our appliances. Please recy-
cle cardboard/paper and plastic packaging ap-
propriately.
CAUTIoN!
Electrical appliances should
not be disposed of with
the household trash.
Electrical appliances contain valuable raw ma-
terials. When an appliance is worn-out, please
take it to a recognised recycling facility. Please
consult the local authorities for information on
recycling appliances.
Customer service
In the event that your Cloer appliance becomes
defective, please contact your Cloer dealer or
Cloer customer service department. Cloer elec-
trical appliances comply with current EC guide-
lines and safety regulations.
Conditions of warranty
Cloer grants you, the private end user, a
limited manufacturer's warranty. Assuming
careful handling and compliance with the ope-
rating instructions and safety notices, we will
be obligated to replace the appliance at no
cost, insofar as there are defects in material or
workmanship. The repair will be effected by
repairing or replacing defective components.
Solution
Plug the
power plug
into the
EN
wall socket
Please see
page 9 under
"Overheating
protection
device"
Add less
water, do not
exceed the
MAX marking
Add more
water / do
not come
below the
MIN marking
(= 0.8 l)
Decalcify
the electric
kettle
Decalcify
the electric
kettle
9
Inhoudsopgave
