Inhoudsopgave
Advertenties
eNet
Radiografische wandzenders
Channel 1
Channel 2 *
Channel 3 *
Channel 4 *
Settings, channel/scene
Parameter name
Local Operation
Manual commissioning
Sum status / transmission
repetitions
* Channel 2 to 4 only for multi-channel wall transmitters
6.3 Hulp bij problemen
Na kort indrukken van de toets knippert de rode LED.
Oorzaak: batterij in de wandzender is bijna leeg.
Batterij vervangen (zie hoofdstuk Batterij plaatsen).
32579203
J:0082579203
Rocker switch, scene
Basic setting: Rocker switch
Rocker switch, scene
Basic setting: Rocker switch
Rocker switch, scene
Basic setting: Rocker switch
Rocker switch, scene
Basic setting: Rocker switch
Setting options, Basic set-
ting
On, Off
Basic setting: On
On, Off
Basic setting: On
On, Off/Transmit 2x...11x,
Off/Transmit 4x (without con-
nection)
Basic setting: On
9/10
Setting the buttons of the
channel as channel buttons
(rocker switch) or scene but-
tons (scene).
Setting the buttons of the
channel as channel buttons
(rocker switch) or scene but-
tons (scene).
Setting the buttons of the
channel as channel buttons
(rocker switch) or scene but-
tons (scene).
Setting the buttons of the
channel as channel buttons
(rocker switch) or scene but-
tons (scene).
Explanations
Blocks the device channel for
local operation.
Blocks manual commissioning
for the device channel. In the
"Off" setting, the device can-
not be reset to the factory set-
ting.
On: The transmitter evaluates
the received status messages
and displays them as an over-
all status. If individual status
messages fail, then the trans-
mitter will repeat its telegram
up to three times. Off/Transmit
... times: The evaluation and
display of the overall status is
deactivated. The number of
telegram repetitions is prescri-
bed. In this setting, no trans-
mission errors are displayed.
Off/Transmit 4x (without con-
nection): Reserved for sensors
which transmit without a con-
nection.
20.03.2014
Advertenties
Inhoudsopgave
