Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Important!
Your party-tent heater must be installed fully and fulfil all the relevant
electricity regulations, requirements and rules. If you are in any
doubt, have the device installed by a qualified electrician.
This equipment must be connected to a fully functional, undamaged,
single-phase, earthed electrical socket which provides 220-
240V/50Hz current. The installation must be equipped with a 30 mA
earth leakage circuit breaker.
The plug must always be accessible when the device is connected
to an electricity supply.
Read this instruction leaflet carefully and follow the instructions.
Before connecting the device, always check that:
the voltage to which you wish to connect the device corresponds
the voltage indicated on the specification plate.
the socket and plug correspond to one another.
the socket is earthed.
the device is hanging securely, at the right height and with
sufficient free space around it (see later in the booklet).
the electrical cable is located away from the vicinity of the heater
so as to avoid it getting too hot.
SAFETY WARNINGS
The party-tent heater must only be used in the manner for which
it has been designed: as a hanging heater for party-tents,
verandas and similar covered outdoor areas in a private setting.
Never use it for other purposes such as drying clothing or
textiles or other materials/products/people or animals. The
party-tent heater is not intended to be used in commercial
situations and must not be used at building sites or in
greenhouses, stables etc.
The carbon heating lamps are fragile so handle the party-tent
heater with care. Avoid bumping the device, letting it fall etc.
15
Advertenties
Inhoudsopgave
