Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
eNet
Radiografische jaloezieactor, voor DIN-rail
Transmission of blind/shutter
position > 10%
Behaviour on voltage return
Configured venetian blind
position
Configured slat position
Behaviour after the end of the
disabling function
Priority, lock-out protection
Priority, restraint
Priority, wind alarm
Priority, sun protection
Priority, twilight
Slat change-over time
Fabric-stretching time
82581813
J:0082581813
On, Off
Basic setting: Off
No change
Configured value
Basic setting: No change
0 ... 100 %
Basic setting: 0 %
0 ... 100 %
Basic setting: 0 %
no change
Last value
Down
up
Basic setting: No change
0...4
Basic setting: 1
0...4
Basic setting: 2
0...4
Basic setting: 3
0...4
Basic setting: 0
0...4
Basic setting: 0
0 ms ... 10 sec
300 ms ... 10 s
Basic setting: 0 ms / 300 ms
8/10
The current position of the
blind/shutter is always trans-
mitted when the blind/shutter
comes to a stop. This parame-
ter makes it possible to specify
that, during travel, the position
is saved when the blind/shut-
ter position changes by more
than 10%. The saved value
can then be polled from the
eNet server.
Defines the behaviour of the
output after voltage return.
RMD design: Bus voltage
return
If the value "Configured positi-
on" is entered for the parame-
ter "Behaviour after voltage
return", then the blind/shutter
position set here is approa-
ched.
If the value "Configured positi-
on" is entered for the parame-
ter "Behaviour after voltage
return", then the slat position
set here is approached.
Behaviour of the output when
a block is removed.
Specifies the priority for
recalling and removing a sce-
ne of type Lock-out protection
for the channel.
Specifies the priority for
recalling and removing a sce-
ne of type Forced position for
the channel.
Specifies the priority for
recalling and removing a sce-
ne of type Wind alarm for the
channel.
Specifies the priority for
recalling and removing a sce-
ne of type Sun protection for
the channel.
Specifies the priority for
recalling and removing a sce-
ne of type Twilight for the
channel.
Absolute time for changing-
over Venetian blind slats. The
fabric stretching time can also
be set here for the Awning
operating mode.
12.03.2014
Advertenties
Inhoudsopgave
