Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
11
cleaining & maintenance
Switch the appliance off before cleaning and let it cool down. Do not clean the appliance with a pressure cleaner or steam cleaner.
Interior
Clean the inside of the appliance after every use. Use a damp cloth. To clean the oven thoroughly, an ovenspray may be used. Rinse
well. Dry the inside will a dry cloth.
Accessories
Clean the accessories, such as the baking tray, the grid and the guide rails with warm water and a mild detergent. Dry thoroughly before
reusing.
Exterior
Clean the exterior of the appliance with a damp cloth or sponge. If necessary, clean the exterior with warm water and a mild detergent.
Also clean the oven door and the door seal.
For easy cleaning, the oven door and the guide rails can be removed.
Removing and fitting the guide rails
To remove the guide rail, loosen the screw at the bottom of the rail and lift it from the side. Pay attention to the top of the guide rail
when refitting. Place the guide rail in the holes and tighten the screw at the bottom.
Replacing the oven lamp
Before proceeding, disconnect the appliance from the power line to avoid the possibility of electric shock.
• Unscrew the glass cover of the lamp.
• Replace the light bulb with a new equal bulb (25 W, 230V, E14 connection and must be resistant to high temperatures - upto 300°C).
• Refit the glass cover.
• Plug the appliance in.
Tips for cleaning
• Clean the oven after every use to prevent food residue to stain.
• Grease can be best removed when the oven is still a bit warm. Use warm water and a mild detergent.
• Use for stubborn stains a special ovencleaner. Rinse the residue of the cleaning agent with water.
• Never use any abrasive pads or corrosive cleaners.
• Make sure not to spray on the heating element when using a special ovenspray.
Removing and installing the oven door - IOV6032RVS
The oven door can be removed to clean the interior and the door easily.
• To remove the oven door, open it completely.
• Lift the two levers at the hinges. If necessary use a small screwdriver.
• Carefully close the door as far as the first stop, caused by the raised levers.
• Lift the door upwards and outwards, to remove it from the mountings.
• Place the hinges of the oven door in the mountings. Make sure the door is level.
• Lower the two levers at the hinges back.
• Close the oven door.
24
•
English
Advertenties
Inhoudsopgave
