Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problems
Reasons
There is no electricity.
The water-full indicator will flash.
The ambient temperature is too low or
too high
The appliance
In cooling mode, the room temperature is
does not work.
lower than the set temperature; in
heating mode, the room temperature is
higher than the set temperature.
In dehumidification mode, the ambient
temperature is low.
There is direct sunlight.
Doors or windows are open; there are a
lot of people; or in cooling mode, there
The cooling effect
are other sources of heat.
is not good
The filter screen is dirty.
The air inlet or outlet is blocked.
The appliance is not placed on a flat
Big Noise
surface.
compressor does
Overheat protection starts.
not work.
The distance between the machine and
the remote control is too far.
The remote
control does not
The remote control is not aligned with the
work.
direction of the remote control receiver.
Batteries are dead.
Displays 'E1'.
The room temperature sensor is
abnormal.
Displays 'E2'
The pipe temperature sensor is
abnormal.
Note: If problems not listed in the table occur or recommended solutions do not work, please contact the
professional service organization.
X.Addendum
Schematic diagram for appliance
（The specific technical parameters of the machine shall be subject to the nameplate on the product）
Compresso
r
This symbol on the product or in the instructions means that your electrical and electronic equipment should
be disposed at the end of its life separately from your household waste. There are separate collection
Solutions
Turn it on after connecting it to a socket with
electricity.
Discharge the water inside.
Recommend to use the machine in at the
temperature of 16-35 ℃ (61-95 ℉).
Change the set temperature.
The machine is placed in a room with an ambient
temperature of greater than 17 ℃ (62 ℉).
Pull the Curtain.
Close doors and windows, and add new
appliance.
Clean or replace the filter screen.
Clear obstructions.
Put the appliance on a flat and hard place (to
reduce noise).
Wait for 3 minutes until the temperature is
lowered, and then restart the machine.
Let the remote control get close to the appliance,
and make sure that the remote control directly
faces to the direction of the remote control
receiver.
Replace batteries.
Check the room temperature sensor and related
circuitry.
Check the pipe temperature sensor and related
circuitry.
Capillary
Condense
r
Evaporat
28
or
Advertenties
Inhoudsopgave
