Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installation of Battery
1. Remove the insulating mylar strip from the battery.
It is located at the bottom back side of the remote
control.
2. Loosen the screw on the battery compartment
cover with a screwdriver. Pull out the battery
compartment with your fingernails.
3. Replace a new battery (size 2025) correctly and
fully insert the battery compartment back to the
original position. Tighten the screw with a
screwdriver.
Handling the Remote Control
• Remove the batteries if the remote control is not going to be used for an extended period of
time.
• To avoid possible failure, read the following instructions and handle the remote control
properly.
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under the direct sunlight or near sources of excessive heat.
• Do not use caustic cleaners ( porcelain, stainless steel, toilet, or oven cleaner etc. ) on the
remote control, as it may suffer damage.
Note:
Remove the battery from remote control handset when it is not to be used for a long period.
Otherwise it can be damaged due to leakage of battery.
WARNING
The reset process is as below, please note that all the pre-setting will be default after resetting.
Insert the power code, then long press the stop key, while it display "VXX", press the
stop key for 2s.
soundmaster(NR850&NR850WE)-NRC506,two ant-e1.indd 9
GB-9
2016/6/12 9:10:43
Advertenties
Hoofdstukken
Inhoudsopgave
