Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Step 3: Hold "˄" again for at least 1.5
seconds until the start time starts flashing.
Short press "v" to change minutes and short
press "˄" to change hour. ( fig 1-7)
Step 4: Perform step 3 again to set the End
Time. (see fig 1-7)
Step 5: Hold "˄" for at least 1.5 seconds to
set the Temperature (factory setting is 20˚C)
the 3rd
will start flashing. Use the "v" and
line
"˄" to set the temperature. (see fig 1-8)
Step 6: Hold "˄" again for at least 1.5 seconds to set the next program. Follow steps
1 to 5 again. (see fig 1-6)
1-7 Programming mode
You can also set the towel warmer per day with 2 time slots per day.
Hold the "
" button for at least 1.5 seconds to enter the 1-7 programming mode.
Then follow the steps of the 5+2 programming mode to set the time slots.
Tips:
1. In any operating mode, you can reset the current operating mode parameters by
pressing "˄" for at least 1.5 seconds.
2. In weekly timing mode, OFF indicates when the weekly timing period is not active.
3. When the weekly time period starts, short press "˄" or "v" to change the set
temperature of the current period.
4. Whether it is the 5+2 mode or the 1-7 mode, the default start time is 6:00 PM and
the default end time is 8:00 AM. The standard room temperature is 20˚C.
5. The durations of program 1/2/3/4 may not overlap. The end time must be later than
the start time, otherwise the program will not work.
6. The start and end time must be set at the same time for it to take effect. If only the
start or end time is set, the program will not work.
fig 1-7
21
fig 1-8
Ingestelde
temperatuur
Advertenties
Hoofdstukken
Inhoudsopgave
