Inhoudsopgave
Advertenties
Before start-up
– mains cables, control cables, signal and telecom-
munication lines near the welding or cutting ma-
chine
– TV/radio transmitters/receivers
– Computers and other control devices
– Protection equipment such as alarm systems
– Pacemakers and hearing aids
– Measurement and calibration devices
– Equipment with too little protection against interfer-
ence
If other equipment is disturbed, it may be necessary to
provide additional shielding.
‰ The affected area may go beyond the boundaries of
the property concerned. This depends on the layout
of the building, and the other activities that may be
going on there.
Please use the machine in compliance with the manu-
facturer's instructions. The operator of the equipment is
responsible for the installation and use of the machine.
The owner is responsible for eliminating the interference
caused by electromagnetic fields (possibly with technical
assistance by the manufacturer).
11 Setup and transport
Danger of injury due to the device falling
over and crashing.
Before transport, disconnect the mains plug.
Carry the device using the transportation belt
and keep it in a horizontal position.
Do not use a fork-lift truck or similar device to
lift the machine by its housing or transporta-
tion belt.
The machine must be set up only on firm,
level and dry surfaces. The maximum admis-
sible angle of inclination for setting up is 10°.
Therefore, always ensure that the cooling air
openings are always uncovered.
– Do not set up the device directly by a wall.
– Do not cover any cooling air openings.
The device may overheat and be damaged.
Cooling air openings are located on the
– Front side of the housing
– Rear side of the housing
05.19
12 Brief operating instructions
 Connect the mains or battery cable.
 Connect the component guide and electrode holder to
the sockets 3 and 4.
i
 Tension the stick electrode on the electrode holder.
 Switch the machine on by pressing the On/Off button
17 for 2 sec.
 Select the desired electrode operating mode using the
16 button.
 Set the desired welding current using the rotary knob
12.
9 The machine is now ready for welding.
13 Before start-up
13.1 Fastening the transportation
belt II
 Thread the transportation belt 1 into the welding ma-
chine and plastic slides 8. See sequence of the num-
bering in the picture.
13.2 Connecting the ground cable III
When selecting the working space, ensure that the
ground cable and the ground clamp can be fastened
properly.
The ground clip must be fastened to an exposed
location of the welding table or component, so that it is
highly conductive. It must be located in the immediate
vicinity of the welding area, so that the welding current
cannot seek its own return path across machine parts,
ball bearings or electric circuitry.
Do not place the ground clamp on the welding ma-
chine, as otherwise the welding current will be carried
via the protective conductors and it will destroy these.
Never attach the workpiece connection loosely. Connect
the ground clamp firmly to the welding bench or the
workpiece.
909.2759.9-05
Observe the polarity according to the data of
the electrode manufacturer (see also elec-
trode welding).
- 23 -
Advertenties
Inhoudsopgave
