Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.2
P2.0: Entering the area of the air outlet in cm
Fig. 15: Entering the area
6.2.1
P2.1: Setting the
adjustment factor (only
by Wöhler Service)
6.3
P3.0: RH offset (Wöhler FA 430 only)
If an offset value is entered, the fan anemometer fundamentally adds the entered offset
value to the measured value.
In the P2.0 mode, press the HOLD/MIN/MAX
•
key to access the Area entry mode.
A five-digit figure is displayed. The first digit flas-
hes.
Set the first digit using the Up key.
•
Move to the next digit using the Down key. Set
•
this digit as described above.
•
When you have finished setting the figure,
press the HOLD/MIN/MAX key to save the en-
try and return to the P2.0 mode.
After setting or confirming the area, you enter
•
the P2.1 "rATo" mode. In this mode, settings
for adjusting the anemometer can be made..
ATTENTION !
In this menu P2.1, settings may only be made
byWöhler Service technicians!
Press the Enter key twice to get to the "P3.0"
•
menu.
To return to the measurement display, press
•
and hold the Set button..
In the P3.0 mode, press the HOLD/MIN/MAX
•
key to access the Offset setting mode.
The offset value will now flash in the display
Settings
or inch
2
2
EN
55
Advertenties
Hoofdstukken
Inhoudsopgave
