Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Charging the Bark Control Collar
Excessive charging can shorten battery life. Only charge when you see the low battery light.
1. Lift the rubber cover protecting the charging port and connect the charger.
2. Plug in and fully charge the collar. This can take up to 5 hours.
3. When fully charged, the green LED on the collar will turn off.
4. When the bark control collar is charged, replace the rubber cover.
To Turn the Bark Control Collar On
D
Charging Port
Press and hold the power button (D) until you hear a low to
high beep and the green LED appears, and then release.
The green LED will flash once every 5 seconds.
To Turn the Bark Control Collar Off
Press and hold the power button until the bark control collar
beeps high to low, and then release. The red LED will be
illuminated during the button press and will turn off when the
bark control collar turns off.
Power/LED
Quick Tip: When you are not using the collar, you
will want to turn it off. This will increase the battery life.
LED Function and Response
The two colour LED indicates the battery level. When the battery is low, the red LED will blink
3 times every 5 seconds. When it is fully discharged, no LED will flash. When the collar is
charged, the green LED will flash once every 5 seconds.
Temperament Learning
Temperament Learning tracks the number of stimulations needed to substantially reduce, and
in most cases, eliminate the number of nuisance barks. The collar starts at the lowest static
stimulation level and increases the intensity with each successive back until the barking stops.
This stimulation level becomes the starting level the next time the dog barks. Once your dog
has learned to reduce this barking, the initial warning stimulations are automatically reduced.
NOTE: As a built-in safety feature, if your dog barks 15 times or more within an 80 second
period, the bark control collar will automatically shut off for 3 minutes.
Reset the Stimulation Level
1. Power the collar on. Wait 5-10 seconds or until the first green LED flash.
2. Press and hold the on/off button.
3. Continue holding through the red LED and power off tone.
4. The green LED will flash 5 times to confirm the correction level has been reset to level 1.
5. Release the on/off button. The bark collar will now be powered off.
7
petsafe.com
Advertenties
Hoofdstukken
Inhoudsopgave
