Download Print deze pagina

First Place The Glass Plate With The Cosi Logo - cosi COSISCOOP CEMENT SQUARE Gebruiksaanwijzing

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 7
9.
The appliance creates warm air currents, and these currents could heat wall surfaces and
other objects.
10. Always place this appliance at least one metre (1000 mm) from non-combustible objects.
Nothing can be positioned less than 1000 mm above the appliance. Combustible materials
should not be placed near the appliance; the minimum distance is 1500 mm.
11. DO NOT burn any foreign materials on this fire.
12. Due to the nature of this product, the surface could be very hot. Care should be taken when
operating the appliance.
13. WARNING: Never leave children and pets unattended with this appliance.
14. Make sure you have a fire blanket and powder extinguisher in your home before you use the
appliance. In case of fire: immediately turn the control knob to 'OFF' to stop the gas supply.
In case of fire, immediately place the fire blanket on the appliance and make sure the flames
are not exposed to oxygen. If necessary, extinguish the fire using the powder extinguisher.
NEVER use water or foam extinguishers for fuel fires.
15. For assistance or additional information, please contact the supplying retailer.
3. Installation Cosiscoop
1.
Remove the outer packaging, and read these instructions COMPLETELY before continuing to
unpack or install this appliance. Carefully remove all parts from the box. Please dispose of
all packaging materials in accordance with your local recycling procedures.
2.
Install the appliance by following the requirements mentioned under 'Installation
Requirements'.
3.
Insert the 190 g gas cartridge into the appliance. For
placement, see point 4. 'Inserting the gas cartridge'.
4.
Carefully remove the four glass plates from the
packaging.
5.

First place the glass plate with the Cosi logo

horizontally in the model on the side where the control
button is (see picture on the right). Gently push the
glass down so that it becomes secured between the
iron clips and the outer edge.
6.
Then place the other three glass plates in the model in the same way. Check that all four
glass plates are firmly clamped in the Cosiscoop, so that they do not fall out.
7.
Next, unwrap the pebbles (positioned at the bottom of the appliance) and place them on
top of the appliance.
4. Inserting the gas cartridge
If the gas cartridge inside the appliance is empty, then please read "Removing the Gas
Cartridge".
Remove the glass and pebble stones before placing the gas cartridge. Only use a 190 g
pierceable cartridge with safety valve, as mentioned in point 10. 'Technical specifications'.
This device is equipped with a sealing ring. Always check beforehand if the sealing ring
(between the appliance and the gas cartridge) is still present and undamaged before
connecting the appliance to the gas cartridge. WARNING: Be careful when touching the
sealing ring; it contains a needle.
EN
3

Advertenties

loading

Deze handleiding is ook geschikt voor:

Cosiscoop timber square