Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
2.3.2. Replacing a lost or broken io control point
Reset to the original configuration (see 2.3.3.) and repeat the commissioning steps.
2.3.3. Restoring the original configuration
Attention
• Only perform the double cut-out on the white LED receiver io to be reset!
• This reset deletes all programmed control points.
1) Cut the power supply for 4 s.
2) Switch the power supply back on for approximately 10 seconds
(for at least 5 seconds but no longer than 15 seconds).
3) Cut the power supply for 4 s.
4) Switch the mains power supply back on.
All the LED lights come on then go out.
5) Press the PROG button on the 1W io control point until all the
LED lights come on then go out twice.
The receiver is reset to its original configuration.
6) Repeat the commissioning procedures (see 2.3.).
3. USE AND MAINTENANCE
This product is maintenance-free.
3.1. UP AND DOWN BUTTONS
• To switch the LED light on:
- Briefly press the Up button.
• To switch the LED light off:
- Briefly press the Down button.
͉
͉
Keeping one of these buttons depressed has no effect.
6
Copyright
©
2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
White LED Receiver io
OFF
4 s
5 s
ON
15 s
OFF
4 s
ON
< 0.5 s
< 0.5 s
Advertenties
Hoofdstukken
Inhoudsopgave
